Update products from Veloconnect v2

Update existing products in your store using data from a VeloConnect V2 supplier with Stock Sync.

1. Go to New Setup and select Update existing products in store.
2. Search for and select the VeloConnect V2 template.
3. Enter the required Buyer ID and Password provided by your VeloConnect supplier.
4. Enter your supplier's VeloConnect endpoint in the Base URL field.
5. You can find the endpoint for your supplier in the VeloConnect Suppliers and Endpoints table below.
6. Click Next to continue to the Matching Column section.
7. Continue through the remaining setup steps and review your configuration.
8. Once everything is configured, save the feed and run the update.

Note: The Buyer ID, Password, and Base URL are provided by your VeloConnect supplier. Make sure you use the endpoint that corresponds to your supplier.

VeloConnect Suppliers and Endpoints

You can find the latest supplier and endpoint information on the official VeloConnect implementation page:
VeloConnect — Suppliers and Manufacturers

Use the endpoint listed for your supplier as the Base URL in the VeloConnect V2 setup.

Important: VeloConnect supplier endpoints may change. If your supplier is not listed above or the endpoint does not work, check the official VeloConnect supplier directory for the latest endpoint information.

Updated on: 04/09/2026