Articles on: Frequently Asked Questions (FAQ)

I keep getting the error: "Feed file empty"

If you see the error "Feed file empty" after running a feed, Stock Sync could not access any data from the feed. This usually happens because the feed is empty or no file was detected, which points to a problem with the details entered in Stock Sync.



How to Resolve the "Feed file empty" Error


Check every detail entered for the feed in Stock Sync, then run the feed again.


  1. Check the feed details: Review each detail you entered for the feed in Stock Sync.
  2. Confirm the feed contains data: Make sure the feed you are running is not empty and that its file is available.
  3. Run the feed again: Once the details are corrected, enable and run the feed.


If the error persists, double-check the feed source and file details before running the feed again.



Key Rules & Technical Details


  • Root Cause: The feed is empty or no file is detected in Stock Sync.
  • Required Fix: The feed details entered in Stock Sync must be checked and corrected before the feed can run.



Troubleshooting Steps


  • Issue: "Feed file empty" error after running the feed → Solution: Check every detail entered in Stock Sync, then run the feed again.
  • Issue: Stock Sync cannot access the feed → Solution: Confirm the feed contains data and that its file is detected, then run the feed again.



Good Articles to Continue


Updated on: 17/11/2026

Was this article helpful?

Share your feedback

Cancel

Thank you!